1 Unscrew
To replace the movable crushing plate, pull the grinding stock container
out of its holder and remove the fixed crushing jaw. The screws of the
clamping strip are easily accessible from below. Loosen the clamping
strip and lift out the crushing plate. Insert the replacement jaw or the
previously used jaw which was turned over horizontally from below and
attach it by screwing on the clamping strip again.
6.3.2 Checking the gap width
After installing the crushing plates, it is necessary to check the gap width
between the plates:
1.
Remove the exterior belt guard.
To do so, pull off the edge around the belt guard and remove the
fastening screws.
ð
The flywheel can be turned by hand.
2.
Set the crank to the lowest position.
To do so, pull out the knurled knob of the crank and set the crank
to position "1". Then, let the knob snap into place properly; this
fastens the crushing plate.
Using the device
- 30 -