
Page 6
Tiles
™
Installation Manual
Rectangular Slot
Extended Tab
Connector
Connector Cover
Finished End
Frame
Extended Tabs
Finished End Change of Height
Connector Covers, and Finished
End Covers
1. Position the Covers onto the Frame
Channel so that the extended Tabs pass
through the rectangular slots on the side
of the Frame or Connector.
2. Hold the Cover tight against the Frame or
Connector, and slide the Cover down until
the top of the Cover is flush with the Frame
Top Cap or Connector Top Cap.
3. To remove, hold the bottom of the
Cover, and pull up until it disengages
from Frame or Connector.
Change of Height Finished End
WARNING:
A Change of Height Wedge must be
installed when two Frames or Connectors
of unequal height are connected.
Frame Top Cap must be in place prior to
installing Finished End Change of Height.
Connectors Cover, Finished End Cover, Finished
End Change of Height Cover, Installation
1. Hold the Cover tight against the Frame
or Connector, and slide the Cover down
until the top of the Cover is flush with the
Frame Top Cap or Connector Top Cap.
2. To remove, hold the bottom of the
Cover, and pull up until it disengages
from Frame or Connector.
WARNING:
If the Connector Cover, Finished End or
Change of Height Finished End does not
sit flush with the top of the Frame or Con-
nector, remove the Cover and adjust the
Extended Tabs until the Cover sits flush.
3. Do not use a rubber mallet to force the
Cover down.