Page 11
Tiles
™
Installation Manual
8-Wire Electrical, In-Frame Power Jumper and
Pass-Through Power Jumper Installation
Power Retro
Beltline Power Retro
Beltline Power Retro
In-Frame Power Jumper
Receptacle Bracket
Base Covers
Pass-Through
Power Jumper
WARNING:
Disconnect power before servicing.
WARNING:
All electrical connections must be fully
engaged and locked. A loose connection
can cause fire and/or electrical shock.
This is used to connect power from the
Baseline Power Retro to the Beltline Power
Retro.
1. To install the Flex Conduit Power
Jumper, place connecting end into the
right hand Receptacle Bracket on Power
Retro. Press in until fully engaged, and
the spring tab clicks into position.
2. Repeat this procedure at Baseline
Power Retro.
Pass-Through Power Jumper
This Power Jumper is used to extend power
from a Powered Frame through a Non-Powered
Frame to an adjacent Powered Frame.
It can
only be used at the Baseline Power Retro.
1. To install the Flex Conduit Pass-Through
Power Jumper, open Base Covers of
Frames to be connected. Lay Flex Conduit
at the bottom of the wire management.
Connect Pass-Through Power Jumper to
Power Retro on adjacent Frames. Press
until fully engaged, and the spring tab clicks
into position.