Page 21
Tiles
™
Installation Manual
Worksurface Support End Panels,
and Half Leg Installation
Page 21
End Panel and Half Leg
Installation
1. Position Hanger Clip to End Panel, ei-
ther in a right hand or left hand position
as required.
2. Install and tighten four (4) screws into
outer holes of Hanger Clip.
NOTE: Do not install safety clip at this time.
3. Mount End Panel or Half Leg with bot-
tom Hanger Clip hook engaged in sec-
ond slot from bottom of Frame. Hanger
Clip can be mounted one slot higher or
lower depending on required Worksur-
face height.
NOTE: Safety Clip must be secured to End
Panel and Frame. Failure to do so could
cause product instability and/or physical
injuries.
4. Install Safety Clip into Hanger Frame
and align Clip with pilot holes in Support
Panel. Tighten screws to secure safety
clip.
5. Level End Panel or Half Leg by adjusting
Glide under front end of Support Panel.
Installing Worksurfaces
1. Mount Worksurface onto End Panel or
Half Leg by inserting shoulder screw into
rear slotted hole on top of End Panel or
Half Leg. Push Worksurface back until
Front Spacer screw drops into front hole
of Support Panel.
2. For Half Legs, install Ganging Plates
between adjacent Worksurfaces.
Slotted Hole
Hanger Clip
Safety Clip
Glide