Page 17
Tiles
™
Installation Manual
Worksurface Installation
Page 17
Rectangular Worksurface
Installation
WARNING:
All worksurface support used to support
the same worksurface must be mounted
at the same height.
1. Install Cantilever Bracket on Frame by
inserting the tab on the top hook of the
Cantilever Bracket into the Frame slot at the
desired height. Rotate bottom of Cantilever
Bracket into Frame to engage all hooks.
2. Repeat procedure for Cantilever on other
side of the Worksurface.
3. For Worksurfaces 60” to 84” wide, install
Center Support on center Frame at the same
height as the Cantilevers on the right and left
side.
4. Push down on all Worksurface supports to
ensure all hooks are fully seated in slots.
5. Install Shoulder Screws and Front Spacers
provided onto Worksurface in pre-drilled
holes.
6. Install Worksurface by inserting Shoulder
Screws into keyhole slots in rear of Cantile-
ver Brackets. Push Worksurface back until
Front Spacers engage the front holes in the
Cantilever Brackets.
7. For Workspaces 60” wide or greater, align
Center Support Tab with pilot hole in the
underside of the Worksurface. See picture on
next page.
8. Level Worksurface by adjusting the leveling
screw at the front of the Cantilever Brackets.
9. Install adjacent Worksurfaces as required.
10. Attach Ganging Plates between adjacent
Worksurfaces.
Frame
Tab
Center Support
Top Hook
Cantilever Bracket
Front Spacer
Worksurface
Shoulder Screw
Cantilever Bracket