Page 22
Tiles
™
Installation Manual
Open Metal Worksurface Support Installation
Page 22
NOTE: Open Metal Worksurface Support is
only to be used in End Run Application.
1. Assemble Bracket and Spacers as
shown. Adjust for right or left hand Instal-
lation.
2. Hold Bracket and Spacers together. Install
Bushing and secure with Cap Screw. Do
not tighten. Align Bracket Assembly in the
correct position and tighten Cap Screw.
3. Adjust the height of the Bracket Assembly
by removing the Adjustment Screw. Slide
the inner tube to the desired height and re-
insert Adjustment Screw. Tighten screw.
4. Make sure the Adjustment Screw faces
under the Worksurface and is not visible
from the End of Run.
5. Adjust Safety Clips and Attachment
Bracket for right or left application
6. Align bottom Attachment Bracket with
bottom slot in Hanger Frame. Insert At-
tachment Brackets into Hanger Frame and
push down on Open Metal Worksurface
Support until firmly seated.
7. Insert Safety Clip into Hanger Frame. Align
holes in Safety Clip with holes in Open
Return, and secure Safety Clip with screws
provided.
Note: Safety Clip must be secured to Open
Return and Frame. Failure to do so could cause
product instability and/or physical injuries.
8. Install Corner Worksurface Bracket to
match the height of the Bracket Assembly.
9. Install Worksurface.
Attachment bracket
Safety Clips
Bracket
Spacers
Front Tube
Corner Worksurface Bracket
Bushing and Cap Screw