freeGuard 100 CLI User Manual
55
Command History
Related Commands
•
config system global, set multicast-forward
5.8 policy
Use this command to add, edit or delete firewall policies.
Firewall policies control all traffic passing through the freeGuard 100. Firewall policies are instructions
used by the freeGuard 100 to decide what to do with a connection request. The policy directs the
firewall to allow the connection, deny the connection, require authentication before the connection is
allowed, or process the packet as an IPSec VPN packet.
Command syntax pattern
config firewall policy
edit <id_integer>
set <keyword> <variable>
end
config firewall policy
edit <id_integer>
unset <keyword>
end
config firewall policy
delete <id_integer>
end
config firewall policy
move <id_integer> {after <id_integer> | before <id_integer>}
end
get firewall policy [<id_integer>]
show firewall policy [<id_integer>]
firewall policy command keywords and variables
Keywords &
Variables
Description
Default
action {accept | deny |
encrypt}
Enter accept to accept packets thatmatch the firewall
policy. If you enter accept you can also enable or
disableauthentication for the policy, enable or
disable nat to make this a NAT policy (NAT/Route
mode only), enable ordisable ippool so that the NAT
policy selects a source address for packets from a
pool of IP addresses added to thedestination
deny
Summary of Contents for freeGuard 100
