freeGuard 100 CLI User Manual
203
ends the current session, but it can try to establish a new
session.
restart_time
<time_str>
Enter daily restart time in hh:mm format.
No default.
syncinterval
<minutes_integer>
Enter how often, in minutes, the freeGuard 100 should
synchronize its time with theNetwork Time Protocol (NTP)
server. The syncinterval number can be 1 to 1440; 0 disables
time synchronization.
0
tcp_option {disable |
enable}
Enables SACK, timestamp and MSS TCP options. For normal
operation tcp_optionshould be enabled. Disable for
performance testing or in rare cases where it impairs
performance.
enable
timezone
<timezone_integer>
The number corresponding to your time zone. Press ? to list
time zones and their numbers. Choose the time zone for the
freeGuard 100 from the list and enter the correct number.
00
Example
This example shows how to change to Transparent mode.
config system global
set opmode transparent
end
This example shows how to display the settings for the system global command.
get system global
This example shows how to display the configuration for the system global command.
show system global
Command History
10.18 ha
Use this command to enable and configure freeGuard 100 high availability (HA). Using the config
system ha command you must configure all cluster members with the same group ID, mode, and
password before putting the cluster into HA mode.
Group ID, mode, and password are not synchronized between cluster units. The primary cluster unit
synchronizes all other configuration settings, including the other HA configuration settings.
Note:
You cannot enable HA mode if one of the freeGuard 100 interfaces is configured using DHCP
or PPPoE. If DHCP or PPPoE is configured, the config hamode keyword is not available.
Summary of Contents for freeGuard 100
