freeGuard 100 CLI User Manual
215
ip6-send-adv
{disable | enable}
Enable or disable the flag indicating whether ornot to send
periodic router advertisements and to respond to router
solicitations.
disable
2forward {disable
|enable}
Enable or disable layer 2 forwarding for aninterface.
disable
lcp-echo-interval
<seconds>
Set the interval in seconds between LCP echo requests.
5
lcp-max-echo-
failures <integer>
Set the maximum number of missed LCP echoes before the PPP
link is disconnected.
3
log {disable |
enable}
Enable or disable traffic logging of connections to this interface.
disable
macaddr
<address_octet>
Override the factory set MAC address of this interface by
specifying a new MAC address.
Factory set.
mode {static | dhcp
| pppoe}
Configure the connection mode for the interface.
static • Configure a static IP address for the interface.
Dhcp• Configure the interface to receive its IP address from a
DHCP server.
pppoe • Configure the interface to receive its IP address from a
PPPoE server.
static
mtu <mtu_integer> Set custom maximum transmission unit (MTU) size in bytes.
Ideally mtu should be the same as the smallest MTU of all the
networks between this freeGuard 100 and the destination of the
packets.
For static mode the <mtu_integer> range is 576 to 1500 bytes.
For dhcp mode the <mtu_integer> range is 576 to 1500 bytes.
For pppoe mode the <mtu_integer> range is 576 to 1492 bytes.
In Transparent mode, if you change the MTU ofan interface, you
must change the MTU of all interfaces to match the new MTU.
You cannot set the MTU of a VLAN larger than the MTU of its
physical interface. Also, you cannot set the MTU of a physical
interface smaller than that of its VLANs.
1500
mtu-override
{enable | disable}
Select enable to use custom MTU size instead of default (1500).
disable
netbios-forward
{disable | enable}
Enable forwarding of NetBIOS broadcasts to a WINS server. Use
the wins keyword to set the WINS server IP address.
disable
padt_retry_timeout
<seconds_integer>
Initial PPPoE Active Discovery Terminate (PADT)timeout in
seconds. Use this timeout to shut down the PPPoE session if it is
idle for this number of seconds. PADT must be supported by your
ISP. Set PADT timeout to 0 to use default.
1
password
<password_str>
Enter the password to connect to the PPPoE server.
No default.
Summary of Contents for freeGuard 100
