126
show
end
config neighbor
Access the config neighbor subcommand using the config router ospf command.
Use this command to manually configure an OSPF neighbor on nonbroadcast networks. OSPF
packets are unicast to the specified neighbor address. You can configure multiple neighbors.
Command syntax pattern
config neighbor
edit <id_integer>
set <keyword> <variable>
end
config neighbor
edit <id_integer>
unset <keyword>
end
config neighbor
delete <id_integer>
end
config neighbor
edit <id_integer>
get
end
config neighbor
edit <id_integer>
show
end
Note:
Only the ip keyword is required. All other keywords are optional.
neighbor command keywords and variables
Keywords & Variables Description
Default
cost <cost_integer>
Enter the cost to use for this neighbor. The valid range for
cost_integer
is 1 to 65535.
10
ip <address_ipv4>
Enter the IP address of the neighbor.
0.0.0.0
poll-interval
<seconds_integer>
Enter the time, in seconds, between hello packetssent to the
neighbor in the down state. The value of the poll interval must
be larger than the value of the hello interval. The valid range for
10
Summary of Contents for freeGuard 100
