Operation Maintenance Manual
Safety Spinning Wrench
PN 9GV73109-D - Revision: 02 2018-05
72
IN
SP
EC
TIO
N /
M
AI
N
TE
NAN
C
E
6
Inspection / Maintenance
This chapter contains important information on how to
service your machine safely, correctly and economically. It
helps to avoid dangerous situations and reduce repair costs
and downtimes. Following this information will increase
the reliability and service life of the machine.
Ensure that only sufficiently qualified
and trained personnel accomplish
setup and installation work.
Read these instructions carefully before
setting up the machine and putting it
into service.
WARNING
Separated pneumatic lines pose an
injury hazard!
Compressed air can escape under high
pressure. Particularly hazardous are
small dirt particles, which can hit the
eye under high pressure.
ALWAYS relieve pressure in machine
before performing maintenance work.
WEAR EYE PROTECTION!
WEAR PROTECTIVE HELMET!
WEAR PROTECTIVE GLOVES!
WEAR SAFETY SHOES!
Instructions for inspection and
maintenance
1. In the event of visible damage or excessive wear,
contact the FORUM Handling Tools
Service
Department or an authorized repair company.
2. Ensure that exclusively the FORUM Handling
Tools Service Department or an authorized repair
company observing the FORUM Handling Tools
welding instructions performs welding work on cast
parts.
3. Ensure that all other maintenance work is performed
only by personnel trained for this work and familiar
with the risks involved in operating the machine.
4. Ensure that all repair work not performed
by FORUM Handling Tools
is nevertheless
accomplished in compliance with the manufacturer's
specifications and instructions.
5. Small cracks and irregularities, which do not affect
the safety or proper operation of the SSW-40, can
be removed by grinding (see Critical Areas).
6. After repair always, check the repaired part in a
suitable manner to ensure that the defect has been
remedied.
Prerequisites for maintenance work
1. Ensure that the SSW-40 is set down on a good
supporting surface so that it cannot tip.
2. Provide for sufficient lighting at the workplace.
3. The SSW-40 must be removed from the well.
4. Ensure that machine is disconnected from
pneumatic system.
Trouble shooting
1. In all events where the SSW-40 function are not as
expected, following checks must be carried out to
identify the cause.
2. Check all pneumatic connections for proper
condition.
3. Check proper lubrication.