FLOOR PANEL CAPS & OSB SHEETS
The components provided will be labelled
accordingly to the components list, at the back of
this guide book.
Pre-drill and use 4 x 125mm screws and ensure
each screw goes into the bearer beneath. Screw
35mm screws in between the 125mm screws.
Repeat process for the other floor capping.
13
13
Ensure that all OSB sheets fit proportionally onto
your floor.
17
17
Using 35mm screws, screw 3 across the top and 5
down the sides of each OSB sheet. Screw along
the edges first.
15
15
Insert and knock the floor capping (AN) into place
using a rubber mallet. Ensure it is flush to all
edges.
12
12
Apply OSB floor sheets (AD & AE) on top of the
SIPS panels one at a time. Ensure they are flush
to all edges and screw into the corners to keep
secure.
14
14
Some pieces may be oversized. If this is the case,
saw the excess off after the piece is screwed into
place, to create a flush finish.
18
18
Screw the central screws into place, resulting in 3
in a row. This will result in 15 x 35mm screws per
OSB sheet.
16
16
11b
11b
7
