PLASTIC ROOF TRIMS
Apply the piece previously cut to size. Ensure it
is flush to the front edge and butt up against the
plastic trim already pinned into place.
135
135
Simply break the excess off to produce the
required gap as shown above.
139
139
Using the pins provided, pin into place. Repeat on
the opposite corner.
141
141
Before applying the corners onto the trims, you
need to remove the plastic support. Use a Stanley
knife to score an outline to weaken the support.
138
138
Use the clips provided to clip the pieces together.
Repeat the same process on the opposite side.
136
136
Measure and cut the plastic trims into 2 equal
pieces. Ensure each end meets the side trims. Pin
these into place. Add the clip in the centre of the
adjoining trims.
137
137
Once the plastic trims are complete around the
roof, using a Stanley knife remove all of the EPDM
excess. Use the plastic trims as a guide. Be careful
not to cut the T&G panels behind.
142
142
Hook and position onto the corner. Pre-drill to
provide a hole for the pin.
140
140
24