21. Starting with the adjustment knob in approximately the halfway position, lower the driver's window
and exit the vehicle.
22. Press the LOCK button on the vehicle's RKE fob to arm the VSS system. The LED will light solid
for 20 seconds and then begin to flash a steady on/off sequence to indicate the system is armed.
23. Using a closed fist, impact the steering wheel with moderate force to simulate a light impact on the
vehicle. If the impact is detected, the horn will honk and the lights will flash 1 time to indicate the
warning impact was detected.
24. Using a closed fist, impact the steering wheel with heavy force to simulate a hard impact (i.e. glass
breakage) on the vehicle. If the impact is detected, the horn will honk and the lights will flash a
steady on off sequence to indicate the heavy or full shock trigger was detected.
25. Increase (rotate clockwise) or decrease (rotate counter-clockwise) the adjustment knob as necessary
to achieve desired sensitivity, repeat the previous steps to test, and verify adjustment.
Install Trim
26. Install the upper cowl side trim panel.
27. Install the LH IP side trim panel and position the LH weather strip back.
28. Install the steering column opening trim panel.
VSS Functional Test
NOTE:
Observe the LED while performing these tests.
29. Lower the driver's door window, then close all doors, hood, and trunk/hatch and press lock on the
keyfob. The LED should stay lit for 20 seconds while the VSS system pre-arms, after which it will
flash every 3-4 seconds in fully armed mode.
INSTALLATION (Continued)
2013 Fusion
Vehicle Security
9
Page 9 of 10
SK9L3Z-19G361-AA
© Copyright Ford 2012 FoMoCo