INSTALLATION (Continued)
Secure The Control Module Harness and
53.
Programming Options: Entering
Control Module
Programming Mode
See chart below for programming information.
46. Use the supplied tie wraps to secure the control
Option Bank - 1 Chart (4 - Honks)
module harness wires.
BANK
OPTIONS
DESCR
LED
47.
NOTE:
Do not mount the control module in
1
1
LITE
NOTE 1
the knee bolster area.
TOUCH
To ensure the best performance of the built-in
ADJUST
shock sensor, secure the control module at three
1
2
FULL
NOTE 1
points to the vehicle.
SHOCK
ADJUST
Use the supplied long tie wraps to mount the
1
3
DOOR
ON
control module to the underdash wiring harness.
AJAR
INVERT
Install Trim
1
4
UNLOCK
ON
SENSE
48. Install the right hand scuff plate, cowl trim
INVERT
panel and fuse door panel.
49. Assemble the upper and lower steering column
Program Bank 2 Chart (5 Honks)
shrouds, and install the 3 lower shroud screws.
BANK
OPTIONS
DESCR
LED
2
1
STARTER
ON
50. Install the steering column opening trim panel
INTERRUPT
reinforcement.
Install the 4 bolts.
NOTE:
Perform proper adjustments following the
•
Tighten to 9 Nm (80 lb-in).
’’Shock Sensor Setting Procedure‘‘ contained within
this document.
51. Install the lower instrument panel steering
column cover and screws.
54. Open the driver door.
52. Install the left hand scuff plate and cowl trim
•
All other doors should remain closed.
panel.
55. Turn the ignition key to the RUN position.
Programming
56. Press and hold the VSS override button for at
least 10 seconds.
NOTE:
Make sure that the hood and doors are
closed before proceeding.
After 10 seconds the horn with honk 3 times,
indicating the system is now in the learn mode.
NOTE:
The LED on the VSS harness must be
visible to complete module programming.
NOTE:
The VSS override button must be
accessible.
2013 Mustang
Vehicle Security
6
Page 6 of 8
SK9L2J-19G364-AA
© Copyright Ford 2012 FoMoCo
