background image

mod.

 6012.1074/UK - 02/04

2

1

4

3

AS 80

REMOTE-CONTROL ALARM UNIT

OPERATING INSTRUCTIONS

1. REMOTE CONTROL

REMOTE CONTROL UNIT BATTERY LOW

The LED on the remote control flashes when a button is pressed.

When engaged, the alarm causes the direction indicators to flash 6 times quickly

instead of 3.

2. ARMING

The alarm unit engages only with the key contact off.

Press button P2 of the remote control unit

This is confirmed by 3 flashes of the direction indicators and 3 audible chirps

(if on)

The doors lock and the LED comes on steady.

3 x

3 x

AUX output

DOOR UNLOCKING

OFF

DOOR LOCKING

ON

PANIC alarm

3. PROTECTION

After an initial neutral time of 40 seconds, the LED starts to flash and the sensors

are ready to determine all possible alarm causes.

POSSIBLE ALARM CAUSES

Door - hood - trunk opening

Passenger compartment intrusion detected by modules connected to the alarm unit

Ignition attempt

Current absorption

4. ALARM SIGNAL

The triggering of an alarm generates an acoustic and optical alarm cycle lasting 30 sec.

The alarm cycle, for each of the possible causes, can be repeated for at most 8

consecutive times.

ALARM SIGNAL SWITCH-OFF

To interrupt an alarm cycle, press button P1 of the remote control. The alarm unit is

not disarmed.

5. DISARMING

Press button P1 of the remote control

This is confirmed by 1 flash of the direction indicators and 1 audible chirp (if on)

The doors are unlocked, the LED goes off and the dome light comes on (if

programmed and connected).

30 sec

30 sec

ALARM

CYCLE

1 x

25 sec

1 x

ALARM MEMORY

If, during the previous arming time, a cause of alarm has been found, when the alarm

unit is disarmed, two audible chirps will be heard and the LED will flash in a codified

sequence, indicating the cause of the alarm.

2 x

ALARM

MEMORY

6. ARMING WITH MODULE DISENGAGEMENT

To arm the alarm without engaging the connected electronic modules (power windows,

volumetric protection...) press the P2 button of the remote control for over 2 seconds.

Disengagement of the modules is indicated by 6 flashes of the direction indicators.

7. ARMING WITH SIREN DISENGAGEMENT

To arm the alarm without engaging the siren (optical alarm cycles only) press the P2

button of the remote control and, within 15 seconds, the P3 button.

Disengagement of the siren is confirmed by 3 additional audible chirps

SIREN

DISENGAGED

6 x

2 sec

6 x

DISENGAGED

MODULES

1 x

= Current absorption

2 x

= Electronic modules

3 x

= Ignition attempt

4 x

= Door - hood - trunk opening

5 x

= Hood opening

6 x

= Radio module

8. TEMPORARY DISENGAGEMENT OF AUDIBLE CHIRPS

If these are switched on, the alarm unit emits audible chirps every time the alarm unit

is armed/disarmed. To temporarily disengage these signals, press button P3 from the

remote control before pressing P2 (on) or P1 (off).

Disengagement only refers to subsequent arming/disarming.

9. PANIC ALARM

By pressing buttons P1 and P2 of the remote control together, the alarm unit performs
an alarm cycle.

During installation, it is only possible to select the panic alarm  with the unit on or off.

To interrupt the panic alarm, press button P1 on the remote control.

10. CAR LOCATOR

With the alarm engaged, by pressing button P2, the direction indicators and the dome

light come on for 25 seconds.

This function facilitates vehicle localisation.

11. STORED REMOTE CONTROLS CHECK

Every time the dashboard is switched off, the LED emits a number of flashes equivalent

to the number of remote controls stored in the unit. This permits checking that the

number of enabled remote controls corresponds to those in possession of the user.

30 sec

30 sec

25 sec

25 sec

ALARM

ON

n x

n=number of enabled remote controls

12. VALET MODE

When valet mode is engaged, all the alarm functions are disengaged. The system

is configured as simple remote-controlled locking unit.

The VALET mode is indicated by continuous LED flashing, with dashboard on.

ENTERING VALET MODE

Switch on the dashboard

Press buttons P1 and P2 at the same time for at least 2 seconds.

The alarm unit gives 1 flash of the direction indicators and 1 audible chirp

With the dashboard off, the LED flashes continuously

VALET

MODE

1 x

1 x

2 sec

UK

Reviews: