20. EMERGENCY SYSTEM DISARMING
Emergency disarming code
The emergency disarming code (factory set = 1111) can be customised by the user.
Note down the new emergency disarming code in the spaces provided.
EMERGENCY SYSTEM DISARMING PROCEDURE
•
Switch the dashboard on and off 3 times in rapid succession
The LED starts to flash
•
Switch the dashboard on after counting a number of flashes equal to the first
figure of the emergency disarming code.
The LED goes off - FIRST FIGURE ENTERED
•
Switch off the dashboard
The LED starts to flash again
•
ASwitch on the dashboard after counting a number of flashes equal to the second
figure of the emergency disarming code.
The LED goes off - SECOND FIGURE ENTERED
•
Switch off the dashboard
The LED starts to flash again
…
•
Repeat the operation for all four figures of the emergency disarming code.
After entering the fourth exact figure, the control unit goes off, unlocking the doors
and giving 1 flash of the direction indicators and two audible chirps.
If the emergency system disarming procedure is performed during an alarm cycle,
the entering of the first exact figure causes the siren to go off.
ENGAGEMENT
•
With the dashboard switched on and doors LOCKED, press the P2 button from the remote control.
The LED comes on steady.
DISENGAGEMENT
•
With the dashboard switched on and doors LOCKED, press the P1 button from the remote control.
The LED goes off.
SPAL srl - Via per Carpi 26/B - 42015 Correggio (RE) - ITALY - Tel.+39/0522/731311 - Fax.+39/0522/693611 - www.spal.it - E-mail: [email protected]
6
5
8
7
EXITING FROM VALET MODE
•
Switch on the dashboard
•
Press buttons P1 and P2 at the same time for at least 2 seconds.
The alarm unit gives 1 flash of the direction indicators and 1 audible chirp
13. AUTOMATIC DOOR LOCKING AT SWITCH-ON
If engaged, the alarm automatically locks the doors 10 seconds after the dashboard
has switched on.
When the dashboard switches off, the doors are automatically unlocked.
VALET
MODE
1 x
1 x
2 sec
10 sec
DISARMING
With the alarm unit armed in passive mode, when a door is opened, an intermittent
audible chirp is heard lasting 10 seconds, during which time the alarm unit can be
disarmed before this generates an alarm cycle.
10 sec
30 sec
ALARM
ON
14. ALARM PASSIVE AUTOARMING
If engaged, the alarm engages automatically 30 seconds after the vehicle has been
left (last door closed).
The passive autoarming of the alarm does not lock the doors and does not engage
the electronic modules connected to the alarm unit, and is indicated in the same way
as arming from remote control.
DISARMING
•
Switch on the dashboard
•
Press button P1 of the remote control unit
•
Alternatively, arm/disarm the alarm system.
90 sec
15. ENGINE CUT PASSIVE AUTOARMING
If engaged, the alarm automatically cuts the engine 90 seconds after the dashboard
switches off.
Passive arming of the engine cut is indicated by the LEDs coming on with short switch-
offs.
18. ANTI-CARJACK
If engaged, in case of the car being broken into, the alarm unit gives alarm signals
and engages the engine cut.
The anti-carjack function can work in two distinct ways, active or passive, depending
on the carjack mode.
The anti-carjack function is only operative after it has been engaged.
16. AUTO REARM
If engaged, the alarm automatically engages 90 seconds after disarming from remote
control, unless a door has been opened meantime. The alarm engages without locking
the doors and without switching on the connected electronic modules.
17. AUTO REARM WITH DOOR LOCKING
If engaged, the alarm automatically engages 90 seconds after disarming from remote
control, unless a door has been opened meantime.
The alarm engages, locking the doors and maintaining the settings defined during
previous arming.
90 sec
3 x
3 x
90 sec
3 x
3 x
ANTI-CARJACK
ON
ANTI-CARJACK
OFF
ANTI-CARJACK - OPERATION
ACTIVE MODE - CARJACK DURING VEHICLE DRIVING
•
The LED comes on steady - anti-carjack on
•
Opening and closing of a door (the drivers is forced by the carjacker to leave the
vehicle)
The LED goes off and, after 20 seconds, starts to flash
The alarm fails to respond to the remote control
After 2 minutes, the control unit performs an alarm cycle, without arming the
engine cut
When the engine is next switched off, the engine cut engages
•
The only way to release the engine is to re-enable the remote control and enter
the emergency disarming code
PASSIVE MODE - CARJACK ON FETCHING VEHICLE
•
The LED comes on steady - anti-carjack on
•
Switch the engine off before opening a door
•
Exit from the car and lock it. The alarm works normally
•
On returning to the car, disarm the alarm by means of the remote control
•
Enter the emergency disarming code
If the disarming code is not entered, the LED remains on steady
The alarm fails to respond to the remote control
After 2 minutes, the control unit performs an alarm cycle, without arming the
engine cut
When the engine is next switched off, the engine cut engages
•
The only way to release the engine is to re-enable the remote control and enter
the emergency disarming code
AUX OUTPUT
ON
19. AUX OUTPUT ENGAGEMENT
When the button P2 on the remote control is pressed twice, the AUX output of the
alarm is engaged. This can be used to control various vehicle electric functions.
The output remains engaged for as long as the button is kept pressed the second
time.
3 x
1
2
3
9
…
…
………
1 x
figure 1
figure 2
figure 3
figure 4
