INSTALLATION (Continued)
57. Press and release the override button. The horn
63. Press and release the Lock button on the trim
will honk 4 times indicating the system has
switch.
entered the first program bank.
The horn will honk 1 time indicating the system
If not please check the following:
has entered the option 1 of the second program
bank.
•
All door and dome light circuit wire solder
connections.
64. The LED must be ON for option 1. If the LED
•
The key is in the RUN position.
is illuminated no action is required. If the LED
•
The software cartridge is firmly seated in
is not illuminated press the Unlock button and
the VSS module.
verify the LED illuminates.
•
The VSS harness connections are firmly
The VSS module is now programmed.
seated in the VSS module.
Functional Test
NOTE:
If you require additional assistance: CALL
1-800-FORD KEY.
NOTE:
If during any of the functional test steps the
VSS system or vehicle does not react or perform
58. Press and release the Lock button on the trim
accordingly please refer to the VSS troubleshooting
switch 3 times.
guide.
The horn will honk 3 times indicating the
65. Close the vehicle doors, hood and trunk.
system has entered the option 3 of the first
program bank.
•
The doors will lock in the following steps.
NOTICE: To turn the LED on or off, press and
66. Arm the security system by pressing the lock
immediately release Unlock button on the trim
button on the OEM key fob.
switch.
•
After 15 seconds the LED should light for
about 1 second. During this is the
59. The LED must be ON for option 3. If the LED
’’pre-arm‘‘ period the LED will begin an
is illuminated no action is required. If the LED
on/off flash sequence (about once every 4
is not illuminated press the Unlock button and
seconds) when the system is fully armed.
verify the LED illuminates.
•
The system may not fully arm until the
NOTE:
When programming the VSS module, if the
dome light is off.
Lock button is held for more than 3 seconds, the
•
If the dome light is not off the system will
horn will honk 4 times indicating the system
remain in the ’’pre-arm‘‘ state after 15
returned to the factory default settings. If this
seconds. During this time the LED will be
occurs, return to step 1 of the programming section
constantly lit.
to reprogram the VSS module.
•
The system will arm when the dome light
goes off and the LED will start to flash
60. Press and release the Lock button on the trim
about every 4 seconds.
switch.
The horn will honk 4 times indication the
67. Disarm the VSS by pressing unlock on the
system has entered the option 4 of the first
OEM key fob.
program bank.
•
The LED should stop flashing indicating
that the security system has disarmed.
61. The LED must be ON for option 4. If the LED
is illuminated no action is required. If the LED
68. Open the driver’s door.
is not illuminated press the unlock button and
verify the LED illuminates.
Enter the vehicle.
•
The VSS system should not trigger at this
62. Press and release the override button. The horn
point.
will honk 5 times indicating the system has
entered the second option bank.
2013 Mustang
Vehicle Security
7
Page 7 of 8
SK9L2J-19G364-AA
© Copyright Ford 2012 FoMoCo
