47. Connect one of the Green/Violet wires from the diode harness to the White passengers door ajar
circuit wire at BCM C2280G Pin 22.
Power Connection
48.
NOTE:
A DVOM connected to the correct wire will show 12V with the key in any position.
A logic probe will show power on the correct wire with the key in any position.
Identify Yellow/Red Battery circuit wire
DW%&0&$3LQ
.
49. Connect the Red wire from the control module harness to the Yellow/Red Battery circuit wire
at BCM C2280A Pin 1.
Program The VSS System
50. Refer to the VSS programming section for this vehicle.
Secure VSS Harness and Control Module
51. Use the supplied tie wraps to secure the VSS harness wires.
52.
NOTE:
Do not mount the control module in the knee bolster area.
To ensure the best performance of the built-in shock sensor, secure the control module at three
points to the vehicle.
Use the supplied long tie wraps to mount the VSS control module to the underdash wiring harness.
All Vehicles
53. Install the upper and lower steering column shrouds.
Install the retainers.
54. Install the glove compartment.
55. Install the RH lower Instrument panel Insulator.
INSTALLATION (Continued)
46.
NOTE:
A DVOM connected to the correct wire will show 0V, then show open when the passengers door is
open.
A logic probe will show ground on the correct wire, then show open when the passengers door is
open.
Identify the White passengers door ajar circuit wire at BCM C2280G Pin 22.
2013 Fiesta - Push Button Start
Vehicle Security
9
Page 9 of 9
SK9L3Z-19G361-AA
© Copyright Ford 2012 FoMoCo
