Ford VSS, Manual

Page: 61 / 89

2013
Fiesta
- Push Button Start
Vehicle Security 1
GENERAL PROCEDURES
5. Press and hold the VSS override button for at
least 10 seconds.
After 10 seconds the horn with honk 3 times,
indicating the system is now in the learn mode.
6. Press and release the override button. The horn
will honk 4 times indicating the system has
entered the first program bank.
If not please check the following:
• All door and dome light circuit wire solder
connections.
• The key is in the RUN position.
• The software cartridge is firmly seated in
the VSS module.
• The VSS harness connections are firmly
seated in the VSS module.
NOTE: If you require additional assistance: CALL
1-800-FORD KEY.
7. Press and release the Lock button on the trim
switch
3
times.
The horn will honk
3
times indicating the
system has entered the option
3
of the first
program bank.
NOTICE: To turn the LED on or off, press and
immediately release Unlock button on the trim
switch.
8. The LED must be ON for option
3
. If the LED
is illuminated no action is required. If the LED
is not illuminated press the Unlock button and
verify the LED illuminates.
NOTE: When programming the VSS module, if the
Lock button is held for more than 3 seconds, the
horn will honk 4 times indicating the system
returned to the factory default settings. If this
occurs, return to step 1 of the programming section
to reprogram the
VSS
module.
9. Press and release the Lock button on the trim
switch.
The horn will honk
4
times indication the
system has entered the option
4
of the first
program bank.
Programming
Programming the Module
1. NOTE: Make sure that the hood and doors are
closed before proceeding.
NOTE: The LED on the VSS harness must be
visible to complete module programming.
NOTE: The VSS override button must be
accessible.
Programming Options: Entering
Programming Mode
2. See chart below for programming information.
Option Bank - 1 Chart (4 - Honks)
BANK OPTIONS DESCR LED
1 1 LITE NOTE 1
TOUCH
ADJUST
1 2 FULL NOTE 1
SHOCK
ADJUST
1
3
DOOR ON
AJAR
INVERT
1
4
UNLOCK ON
SENSE
INVERT
Option Bank - 2 Chart (5 - Honks)
BANK OPTIONS DESCR LED
2 1 STARTER ON
INTERRUPT
NOTE: Perform proper adjustments following the
‘‘Shock Sensor Setting’’ Procedures.
3. Open the driver door.
All other doors should remain closed.
4. Turn the ignition key to the RUN position.
Page 1 of 2
SK9L2J-19G364-AA
© Copyright Ford 201
1
FoMoCo