INSTALLATION (Continued)
34. Connect the Green wire from the control
41.
NOTE:
A DVOM connected to the correct wire
module harness to the Yellow/Violet door
will show 12V, when the Headlight Switch is in
unlock circuit wire at the SJB connector
the park lamp position, then show 0V when the
C2280C Pin 4.
Headlight Switch is OFF.
A logic probe will show power on the correct
35.
NOTE:
A DVOM connected to the correct wire
wire when the Headlight Switch is in the park
will show 0V, then show 12V when the door
lamp position, then show ground when the
unlock switch is pressed.
Headlight Switch is OFF.
A logic probe will show ground on the correct
NOTE:
Do NOT splice into any circuits
wire, then show power when the door unlock
leading to the back of the headlight switch.
switch is pressed.
Doing so may lead to headlight switch failure.
Identify the Blue/Green driver door unlock
NOTE:
Wire is located inside wire loom
motor circuit wire at the SJB connector
running to connector C260 but does not
C2280D Pin 28.
terminate. Wire can be found 4’’ from
connector on the side heading toward the
36. Connect the Brown wire from the control
bulkhead of the vehicle in a looped fashion
module harness to the Blue/Green driver door
underneath bright green tape.
unlock motor circuit wire at the SJB connector
Identify the Violet/White parking light circuit
C2280D Pin 28.
wire at the SJB connector C2280E Pin 6.
37.
NOTE:
Connect only if system will be used in
42.
NOTE:
Wire is located inside wire loom
Lot Mode.
running to connector C260 but does not
NOTE:
A DVOM connected to the correct wire
terminate. Wire can be found 4’’ from
will show 12V, then show 0V when the factory
connector on the side heading toward the
disarm switch is activated.
bulkhead of the vehicle in a looped fashion
A logic probe will show open on the correct
underneath bright green tape.
wire, then show ground when the factory
Connect the White wire from the control
disarm switch is activated.
module harness to the Violet/White parking
Identify the Green/Violet factory alarm disarm
light circuit wire at the SJB connector C2280E
circuit wire at the SJB connector C2280C Pin
Pin 6.
8.
Power Connection
38. Connect the Lt. Green/Black wire from the
control module harness to the Green/Violet
43.
NOTE:
A DVOM connected to the correct wire
factory alarm disarm circuit wire at the SJB
will show 12V with the key in any position.
connector C2280C Pin 8.
A logic probe will show power on the correct
wire with the key in any position.
39.
NOTE:
A DVOM connected to the correct wire
will show 0V, then show 12V when the door
Identify the Blue/Red Battery circuit wire in the
unlock switch is pressed.
ignition switch harness.
A logic probe will show ground on the correct
44. Connect the Red wire from the control module
wire, then show power when the door unlock
harness to the Blue/Red Battery circuit wire in
switch is pressed.
the ignition switch harness.
Identify the Violet/Grey unlock all doors circuit
wire at the SJB connector C2280D Pin 27.
Program The VSS System
40. Connect the Light Green wire from the control
45. Refer to the control module programming
module harness to the Violet/Grey unlock all
section for this vehicle.
doors circuit wire at the SJB connector C2280D
Pin 27.
2013 Mustang
Vehicle Security
5
Page 5 of 8
SK9L2J-19G364-AA
© Copyright Ford 2012 FoMoCo