A logic probe will show ground on the correct wire, then show power when the door unlock switch
is pressed.
Identify the Green/Violet passenger door unlock motor circuit wire at BCM C2280E Pin 23.
37. Connect the Light Green wire from the control module harness to the Green/Violet passenger door
unlock motor circuit wire at BCM C2280E Pin 23.
38.
NOTE:
A DVOM connected to the correct wire will show 0V, then show open when the LH rear door is
open.
A logic probe will show ground on the correct wire, then show open when the LH rear door is open.
Identify the Green LH rear door ajar circuit wire at BCM C2280G Pin 4.
39. Connect one of the Green/Violet wires from the diode harness to the Green LH rear door ajar circuit
wire at BCM C2280G Pin 4.
40.
NOTE:
A DVOM connected to the correct wire will show 0V, then show open when the RH rear door is
open.
A logic probe will show ground on the correct wire, then show open when the RH rear door is open.
Identify the Yellow RH rear door ajar circuit wire at BCM C2280G Pin 3.
41. Connect one of the Green/Violet wires from the diode harness to the Yellow RH rear door ajar
circuit wire at BCM C2280G Pin 3.
42.
NOTE:
A DVOM connected to the correct wire will show 0V, then show open when the trunk is open.
A logic probe will show ground on the correct wire, then show open when the trunk is open.
Identify the Yellow/Orange Trunk Ajar circuit wire at BCM C2280G Pin 7.
43. Connect one of the Green/Violet wires from the diode harness to the Yellow/Orange Trunk Ajar
circuit wire at BCM C2280G Pin 7.
44.
NOTE:
A DVOM connected to the correct wire will show 0V, then show open when the drivers door is
open.
A logic probe will show ground on the correct wire, then show open when the drivers door is open.
Identify the Green/Violet drivers door ajar circuit wire at BCM C2280G Pin 10.
45. Connect one of the Green/Violet wires from the diode harness to the Green/Violet drivers door ajar
circuit wire at BCM C2280G Pin 10.
INSTALLATION (Continued)
36.
NOTE:
A DVOM connected to the correct wire will show 0V, then show 12V when the door unlock switch
is pressed.
2013 Fiesta - Push Button Start
Vehicle Security
8
Page 8 of 9
SK9L3Z-19G361-AA
© Copyright Ford 2012 FoMoCo