109
Ex. 2: To use the TAKE button assigned to Direct mode
Step
Description
1
In Direct mode, the Take function is always
enabled.
Select a crosspoint by selecting a destination
button and source button.
The selected buttons will blink.
* To switch multiple crosspoints, repeat the procedure.
2
After completing the crosspoint selection, press the blinking TAKE button to
switch the crosspoint/s.
In multiple crosspoint switching, the last set of destination and source buttons will
be highlighted.
6-2. Simultaneous Crosspoint Switching
The simultaneous crosspoint switching function allows you to
simultaneously switch multiple
crosspoints
by the press of one button. There are two ways to do so. One is the Salvo function
which performs the switching by recalling the pre-assigned crosspoints. The other is the Take
function which allows you to assign and switch multiple crosspoints simultaneously.
The SALVO crosspoints can be saved to either the
routing switcher main unit
or to
the
remote control panel
.
6-2-1. Main Unit Stored Salvos
This type of salvo allows you to store crosspoint data to be simultaneously switched. The
stored data can be recalled from any connected remote control panel.
Storing Salvo Data to Main Unit
Salvo data for Main Unit can be stored using the Web-based Control.
► See [Web-based Control:
Salvo
page]
Executing Salvos
Use a SALVO (MU RECALL) button on the remote control panel as shown in the procedure
below.
(1) Assign a SALVO button on the remote control panel. Set the salvo for
MU RECALL
, and
select a Salvo number.
► See section 5-4-3-12 “BTN ASSIGN” and 5-5-2. "Button Assignment Change"
(2) Pressing the SALVO button to executes the salvo. The crosspoints stored to the salvo
number are simultaneously set.
6-2-2. Remote Control Stored Salvos
This type of salvo allows to you assign crosspoints to be simultaneously switched to a button.
The salvo can be recalled only by the SALVO button on the remote control panel. Once a
salvo is executed, crosspoints assigned to the salvo are switched according to the current
remote control level setting.
Remote Control Stored Salvo data can also be stored using the Web-based Control.
► See [Web-based Control:
Salvo
page]
