FOR-A MFR-16RUD, Operation Manual

Page: 84 / 157

84
5-4-4. Setting Mode Menu (MFR-39RUA)
The current SRC button functions as an EXIT/CANCEL button used for exiting mode or
processes during Setting mode.
Use the following procedures to change settings.

Press a button to turn On/Off.

Use the control knob to change values.
(1) Press to select a desired menu item.
(2) Turn the control knob to change its value.
(3) Press the control knob to confirm the setting.
After menu setting, do not turn off the remote control unit until the BUSY indicator changes
from lit orange to unlit. Otherwise, settings may not be applied.
* To enter Setting mode, press the SETUP button. The BUSY indicator lights orange during
Setting mode. To exit Setting mode, press the EXIT/CANCEL button. Before powering off
the remote control unit, verify that the BUSY indicator is turned off.
Setting Mode menu items are as shown below.
MENU indication Description Reference
NETWORK
Allows you to change the IP address of the remote control unit
and display the PC-LAN network information.
5-4-4-1
VER/ALARM Allows you to display the version and alarm information. 5-4-4-2
DEFAULT Allows you to change the default settings that are loaded when
the remote control unit is powered on. 5-4-4-3
BUTTON
ASSIGN Allows you to assign functions to user-assignable buttons. 5-4-4-4
INHIBIT Allows you to enable/disable the INHIBIT function for a channel. 5-4-4-5
NAME TYPE Allows you to select the display type for Destination, Source and
Level. 5-4-4-6
BRIGHTNESS Allows you to set the brightness of buttons. 5-4-4-7
RU-RU
CONNECT Allows you to configure a link system of multiple remote control
units. 5-4-4-8
TENKEY Allows you to set TENKEY (numeric keypad) operation. 5-4-4-9
PAGE Allows you to change PAGE settings. 5-4-4-10
SALVO CLEAR Allows you to clear salvo data stored in buttons. 5-4-4-11
5-4-4-1. NETWORK
The following submenus are available in NETWORK setting mode.
Submenu Description
RU NETWORK Allows you to change the IP address of the remote control unit
and display the network information.
PC-LAN NETWORK Displays the network settings of the PC-LAN port.
PC-LAN REBOOT Restarts the PC-LAN port.
NETWORK > RU NETWORK
Menu item Description
IP Displays and changes the IP address of the remote control
unit. The lower 8 bits (the fourth byte) represent the Unit ID.
MASK Displays the subnet mask of the remote control unit.
UNIT NAME Displays the unit name of the remote control unit.