58
If input channels that are not assigned in the
Source Assignment
page are selected on
the switcher, they are replaced with the Alternative Source set in the
Source Assignment
page in the MFR system.
3-4-2. Synchronous Crosspoints Switching
Configure the system as described 1) to 3) in Sec. 3-4-1.
4) Configure channel link settings:
Open the
Re-Entry
page and set the menu page as shown below.
Output
Input
MFR Dst 112
HVS-390HS IN9 > AUX 1
MFR Dst 113
HVS-390HS IN10 > AUX 2
* Physical destination channels must be assigned to these logical destination channels
on the MFR-5000.
5) Assign logical source and destination channels on the MFR-5000 to input channels and
AUX buses on the switcher.
<AUX bus assignments>
a) Open the
Destination Assignment
page.
b) Select
HVS(AUX)
under
Select Table
.
c) Set
Level
to
1
.
d) Assign
AUX1
to
DST 129
.
e) Assign
AUX2
to
DST 130
.
<Input channel assignments>
a) Open the
Source Assignment
page.
b) Select
HVS(AUX)
under
Select Table
.
c) Set
Level
to
1
.
d) Assign
IN1
to
SRC 129
.
After above setup settings are complete:
If
SRC 129
is selected for
DST 129
on the MFR-5000,
IN1
is selected for
AUX1
on the switcher.
If
SRC 3
is selected for
DST 129
on the MFR-5000,
IN9
is selected for
AUX1
on the switcher and
SRC 3
is also selected for
DST 112
on the
MFR-5000.
If
IN9
is selected for
AUX1
on the switcher,
a source assigned to DST 112
is selected for
DST 129
on the MFR-5000
If
IN10
is selected for
AUX2
on the switcher,
a source assigned to DST 113
is selected for
DST 130
on the MFR-5000
DST113
SRC1
SRC2
SRC3
DST129
SRC129
DST130
DST112
