108
6-1-3. CHOP Function
The CHOP function allows you to alternate 2 images to compare the images.
Enabling the CHOP function
(1) Press one of 2 source buttons (source A) to compare the images.
(2) While holding down the source button, press and release another source button (source
B).
Source A and B images alternate.
6-1-4. Crosspoint Switching Using TAKE Function
Crosspoint switching using the
Take
function is available by the remote control panel that is
assigned
Take
.
The
Take
function enables crosspoint switching by the TAKE button.
The
Take
function has 2 modes that can be assigned to different remote control panel
respectively. To select the Take mode, select Preset or Direct under
Take Mode
in in the
[Web-based Control:
RU Settings
page].
Preset mode
Press the TAKE button to enable Take, and select crosspoints, then press the TAKE button
to switch crosspoints.
Direct mode
The Take function is always enabled. Select crosspoints, then press the TAKE button to
switch crosspoints.
Ex.1: To use the TAKE button assigned to Preset mode
Step
Description
1
Press the TAKE button.
The take function will be enabled,
and the button will be highlighted.
2
Select a crosspoint by selecting a destination
button and source button.
The selected buttons will blink.
* To switch multiple crosspoints, repeat the procedure.
3
After completing the crosspoint selection, press the blinking TAKE button to
switch the crosspoint/s.
In multiple crosspoint switching, the last set of destination and source buttons will
be highlighted.
Once a crosspoint switch has been completed, the TAKE button preset mode will be
disabled. The button will return to direct mode.
To switch crosspoints in the preset mode again, repeat the procedure from step 1.
Source A
Source B
Source A
Press source button A.
→ Source A is output.
Holding down source button A,
press source button B.
→ Source B is output.
Release source button
B.
→ Source A is output.
