Fluke CableAnalyzer DSP-4000 Series, User Manual

Page: 46 / 228

DSP-4000 Series
Users Manual
2-28
Turning On the Test Tool
To turn on the test tool, turn the rotary switch from OFF to any one of the
available modes. The power-up screen, which appears for about 3 seconds, shows
the software, hardware, and test standards versions for the main and remote units.
(The remote information is shown only if the remote is on and connected to the
main unit.) For a longer look at the power-up screen, hold down any key while
turning the test tool on. Or, select
Version Information
in the SPECIAL
FUNCTIONS mode.
During this time, the test tool also performs a self-test. If a fault is detected during
the self-test, the following message appears:
INTERNAL FAULT
DETECTED. REFER TO MANUAL
. For information, see “If the Test Tool
Fails” in Chapter 8.
Selecting a Language for Displays and Reports
The test tool displays results and prints reports in English, German, French,
Spanish, Italian, Japanese, and Portuguese. Korean and Simplified Chinese are
also available for some display messages and for reports printed using
CableManager software.
The test tool displays a language selection screen if a language has not been
selected since the tool left the factory. Afterwards, you can change the language as
follows:
1. Turn the rotary switch to SETUP.
2. Press
$ Page Down
to find the language selection.
3. Use
D
to highlight the currently selected language.
4. Press
! Choice
.
5. Use
D U
to highlight the language you want.
6. Press
E
to accept the highlighted language. The test tool’s display now
appears in the selected language.