Fluke CableAnalyzer DSP-4000 Series, User Manual

Page: 124 / 228

DSP-4000 Series
Users Manual
6-2
To recalibrate the test tool, refer to Figure 6-1 and proceed as follows:
OFF
PRINT
MONITOR
SETUP
SPECIAL FUNCTIONS
SINGLE
TEST
AUTO TEST
DSP-4000
CABLE ANAL
YZER
TALK
EXIT
ENTER
TEST
SAVE
1
23
4
FAULT
INFO
DSP-4000
SMART REMOTE
ON
OFF
P
ASS
TESTING TALKING F
AIL
LOW BA
TTERY
TALK
ON
OFF
Test Tool Smart Remote
Calibration
Module
oy77f.eps
Figure 6-1. Connections for Self-Calibration
1. Turn the rotary switch to SPECIAL FUNCTIONS.
2. Use
D
to highlight
Self Calibration
.
3. Press
E
.
4. Connect the test tool to the remote as directed by the displayed messages.
5. Press
T
to start the calibration.
When the calibration is complete, the calibration data and the remote’s serial
number are automatically stored in the test tool’s calibration library.
If the message
SELF CALIBRATION FAIL
appears, check the following:
•
Verify that the test tool and remote are securely connected with the calibration
module.
•
Verify that the connected units are resting on a flat surface.
•
Check the main unit, remote unit, and the calibration module for damaged
connectors.
If the self calibration continues to fail, send the main and remote units and the
cable adapters to the nearest Fluke Networks service center. See “Service Center
Repair” in Chapter 8 for details.