Fluke CableAnalyzer DSP-4000 Series, User Manual

Page: 184 / 228

DSP-4000 Series
Users Manual
8-24
Certification and Compliance
Symbol Description
Conforms to relevant European Union directives.
Listed by Canadian Standards Association.
The test tool complies with the following standards:
CSA Standards: CAN/CSA-C22.2 No. 1010.1-92 + Amendment 2: 1997 Safety
Requirements for Electrical Equipment for Measurement, Control, and Laboratory
Use, Part 1: General Requirements
Safety: CAN/CSA-C22.2 No. 1010.1-92 + Amendment 2: 1997; Overvoltage
Category II, Pollution degree 2, 30 V. EN61010, Amendments 1,
OVERVOLTAGE (Installation) CATEGORY II, Pollution Degree 2 per IEC1010-
1 refers to the level of Impulse Withstand Voltage protection provided. Equipment
of OVERVOLTAGE CATEGORY II is energy-consuming equipment to be
supplied from the fixed installation. Examples include household, office, and
laboratory appliances.
Test Results Memory for the DSP-4100
The 16 MB multimedia card stores the results of at least 250 Autotests with plot
data included. More results can be stored if plot data is not included. The exact
number of Autotests you can store depends on the number of tests run by the
selected test standard. Compatible memory cards with greater or less capacity can
also be used. A 32 MB card is available as an accessory.
CableManager software lets you upload Autotest results to a PC from a memory
card installed in the test tool or a memory card reader.
1 MB Flash EPROM allows firmware and test standard updates.