FLIR TCX series, Instruction Manual

Page: 45 / 150

Setup 6
To delete a tour:
• Click next to the tour you want to delete to remove it from the list.
6.3.3 Scan
An auto scan automatically cycles between a set left and right limit.
To add a scan cycle:
1. Under PTZ > Function , click Scan .
2. Under Scan No. , select the scan cycle you would like to configure.
3. Click Set to open the Set Limits buttons.
NOTE
Setting the left limit also sets the elevation level of the scan. Manually scan the area you wish to in-
clude to select the best elevation for the entire area, then select the left limit.
4. Using the PTZ controls, move the camera to the leftmost point of the scan pattern
you want to set and click Set Left Limit .
5. Move the camera to the rightmost point of the scan pattern you want to set and click
Set Right Limit .
6. Under Speed , click / + or use the slider to set the speed of the scan cycle. Setting a
higher number means the camera will move faster between the left and right limits.
7. Press the Start button to test the scan cycle, then Stop to stop the test.
6.3.4 Pattern
You can set the pattern function to record a series of camera movements to recall later.
To save a pattern:
1. Under PTZ > Function , click Pattern .
2. Under Pattern No. , select the pattern cycle you would like to configure.
#LX400062; r.30885/35920; en-US 37