8 Start-up
8.4 Initialization
PIOX S502ID
2020-01-24, UMPIOX_S502IDV1-2EN
44
8.4
Initialization
During an initialization (INIT) of the transmitter, the settings of the start-up mode are reset to default.
Proceed as follows to execute an initialization:
• When switching on the transmitter: keep BRK and C pressed.
• During the operation of the transmitter: press BRK, C and ENTER at the same time. A reset is executed. Release only
ENTER. Keep BRK and C pressed.
To carry out an initialization, the PIN code has to be entered.
• Enter the defined PIN code.
• Press ENTER.
After the initialization has been executed, the message
INITIALISATION DONE
is displayed.
After the initialization, the remaining settings of the transmitter can be reset to the default settings.
• Select
yes
to reset the remaining settings of the transmitter to factory settings or
no
to keep them unchanged.
• Press ENTER.
If
yes
is selected, the message
FACTORY DEFAULT
DONE
will be displayed. The menus of the start-up mode have to be
processed in their entirety again (see section 9.1).
• Enter the defined PIN code.
• Press ENTER.
Notice!
The PIN code is not reset when initializing.
INPUT PIN-Code
CODE
0000
INITIALISATION
----DONE----
FACTORY DEFAULT?
no
>YES<
INPUT PIN-Code
CODE
0000
Summary of Contents for PIOX S502ID
Page 1: ...PIOX S502ID UMPIOX_S502IDV1 2EN Operating instruction ...
Page 63: ......
Page 64: ......
