Flavor Burst CTP 80SNS-L, Equipment, Maintenance And Operations Manual

Page: 63 / 75

62
4. The flavor button will pulsate and syrup will
start to pump through the line and shut off
automatically after 30 seconds.
If you need to stop the prime function early,
or if the syrup is running fresh and
undiluted, you can press the flavor button
again to cancel the function.
NOTE: WHILE THE PRIME FUNCTION IS
ACTIVE, YOU WILL NOT BE ABLE TO
PERFORM OTHER FUNCTIONS ON THE
TOUCH PANEL.
5. Repeat steps 2-4 for all 8 flavors. Allow
each syrup to prime for the full 30 seconds.
6. Remove the cup from the cup holder and
clean it.
Calibrating the System
In order for the Flavor Burst system to dispense
properly, you must calibrate a few sensors in
this section.
NOTE: CALIBRATE THE SYRUPS ONCE A
WEEK FOR 4 WEEKS WHEN THE SYSTEM
IS FIRST INSTALLED.
1. Press the “System Calibration” section in
the Maintenance Menu. Enter the
Administrator Password if prompted.
2. Weight Sensor Calibration The weight
sensor is an integral part of the automatic
dispensing feature of this system. It detects
when there is a cup in the holder and allow
the user to proceed with the serving;
alternatively, if there is no cup in the holder,
it prevents product from being drawn. It
senses the product filling the cup and stops
dispensing when according to the specified
serving size. It will also stop dispensing if
the cup falls out of the holder.
Touch the WEIGHT SENSOR
CALIBRATION button.