Flavor Burst CTP 80SNS-L, Equipment, Maintenance And Operations Manual

Page: 51 / 75

50
9. Unscrew the locking ring from the switch
jack. Install the threaded post of the jack
through the base panel opening. Secure the
jack using the locking ring from the
underside of the base panel.
10. With the ELE 477 switch now installed,
return the freezer panel to the freezer.
11. Locate the draw switch inside the Door
Assembly and plug it into the integrated
switch jack on the freezer.
Installing the Tube and Cable Rail
The syrup tubes and electrical cables that exit
the Door Assembly are protected and held into
position with the use of a Tube and Cable Rail
on the side of the freezer.
Right Side Rail Installation: Follow these
instructions to mount the standard right-sided
Door Assembly to the right side of the freezer. If
you are mounting a left-sided assembly, skip
down to “Left Side Rail Installation.”
1. Remove the three screws from the right side
freezer panel, just above the drip tray and
below the vents. Install the rail base to the
side of the freezer using these screws.
2. Lay the cables from the Door Assembly into
the rail base so that the ends dangle
towards the back of the freezer. Take the
tube assembly from the back of the Flavor
Burst cabinet and lay them inside the rail
base. Insert the ends of the tubes into the
side hole of the Door Assembly.