
Page 30
Operator‘s Manual FERITSCOPE
®
FMP30
System Setup, Maintenance and Cleaning
Detail of the display Explanation of the displays after power up
No reading appears after powering up the instrument be-
cause the last not closed block does not contain any read-
ings.
If the settings in the Service function
Storage mode
are
[do
not save]
or
[delete upon off]
, no reading will appear
upon power up as well because the readings have either
not been stored at all or have been deleted when the instru-
ment was switched off.
(
10.8 ‘Storage Mode’, beginning on Page 184)
A designation (in this case “sheet”) has been assigned to
the open Application.
(
5.5 ‘Assigning Application Designations’, beginning
Once a designation has been assigned to an Application,
it appears in the information lines of the display, where ap-
plicable alternating with the Application number.
The tolerance limits are enabled in the open Applica-
tion:
(
5.6.1 ‘Tolerance Limits’, beginning on Page 46 and
7.3.5 ‘Measurements With Tolerance Limits Enabled’, be-
ginning on Page 91).
The open Application is set to automatic block creation
(
5.6.3 ‘Automatic Block Size and Block Creation’, be-
ginning on Page 49 and 7.3.6 ‘Measurements With a
Fixed Block Size’, beginning on Page 91).
[n=]
: Number of the single readings stored in the current /
Block size