3
3-10
Using Fiery WebSetup
Subnet Mask (Token Ring)
—If you need to set the subnet mask, enter one of the
following values:
•
255.0.0.0
if the IP address starts with a number less than 128
•
255.255.0.0
if the IP address starts with a number from 128 through 191
•
255.255.255.0
if the IP address starts with a number greater than 191
N
OTE
:
Be sure to confirm the subnet mask setting with your network administrator
before proceeding. In some cases the required setting may be different from those
listed.
Gateway
—If your TCP/IP network has a gateway, and users outside the gateway print
to the Fiery XJ using TCP/IP, enter the gateway address here. Obtain the correct
gateway address from your network administrator.
The gateway address applies to either a Token Ring or an Ethernet network. If TCP/IP
is running on both an Ethernet and a Token Ring network, the gateway address you
enter must be in the same subnet as either the Ethernet or the Token Ring address.
Protocol Setup (AppleTalk)
Enable AppleTalk
—Select to enable Apple Talk if you have an AppleTalk network
connected to the Fiery XJ. This setting enables the Fiery XJ to communicate over
AppleTalk networks.
Select Zone
—The Fiery XJ searches the network for AppleTalk zones in your network
segment. Scroll through the list to select the AppleTalk zone in which you want the
Fiery XJ to appear. If your segment has only one zone, the Fiery XJ is assigned to that
zone automatically.
If no AppleTalk zone can be found, your network may have no defined zones, or else
the network cable has not been connected (see page 5-4). Choose OK.
Protocol Setup (IPX Frames)
Select Frames
—Click the Select Frames button to specify IPX frames used with
NetWare. See your network administrator to verify which frame type to choose.