2
2-15
Network Setup options
Ignore EOF Character
Yes/No [No]
This option appears only if
Enable Parallel Port
is set to
Yes
. This option specifies that
the Fiery XJ should ignore end-of-file (EOF) messages in a file. This option must be set
to
Yes
to print PostScript files in binary format (not ASCII); under normal
circumstances, it should be set to
No
. When this option is set to
Yes
, the Fiery XJ uses
the parallel port timeout value to determine when the end of the file has been reached.
When you have configured the port options, choose another port type, or choose Exit
Port Setup and proceed to Protocol Setup.
Protocol Setup options
AppleTalk Zone
List of zones
The Fiery XJ searches the network for AppleTalk zones in your network segment.
Scroll through the list to select the AppleTalk zone in which you want the Fiery XJ to
appear. If your segment has only one zone, the Fiery XJ is assigned to that zone
automatically.
The message “No AppleTalk zone found” may mean your network has no zones, or the
network cable is not connected (see page 5-4). Choose
OK
.
To configure the Fiery XJ, choose each protocol and enter the settings for that
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication
simultaneously.
Network Setup
Protocol Setup
AppleTalk Setup
Enable AppleTalk
Yes/No [Yes]
Select
Yes
if you have an AppleTalk network connected to the Fiery XJ. This
setting enables the Fiery XJ to communicate over AppleTalk networks.
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup
