I
NSTALLATION
31
Completing installation and starting up
To finish the installation of the E-41 at the customer site, make sure to do the following:
1. Affix the EFI/Fiery decal to the engine (see
).
2. Make sure that the copier/printer is powered on.
3. Power on the E-41 (see
).
Make sure that the power cord is attached and that the power switch on the back panel is in
the ON position. Press the power button on the front panel once and release the button. The
power supply automatically senses the correct voltage.
4. When the E-41 has finished starting, access the Fiery menu screen by pressing the
“fierydriven®” button on the copier/printer display panel (see
The E-41 takes approximately three minutes to power on and display Idle on the Fiery menu
screen of the copier/printer display panel.
5. Perform any required system software upgrades (see
Microsoft Windows operating system updates should be obtained from Microsoft directly.
Because such updates are available directly from Microsoft, EFI does not maintain or provide
these updates via the System Updates feature.
6. Print the Test Page and Configuration page (see
) and ask the customer to verify the
output.
7. If more than one E-41 is (or will be) installed at the customer site, advise the site
administrator that it may be helpful to create a backup of the Setup configuration settings
and place the backup file on a thumb drive or CD, which can then be used to configure Setup
on other E-41 print servers. For details, see
Configuration and Setup
.
8. Ask the network administrator to perform Setup and print some test documents over
the network.
9. Store the output and the current Configuration page(s) near the copier/printer.
10. Inform the site administrator that the E-41 user software must be installed on networked
computers that print to the E-41.
11. Ask the site administrator to make sure that all media (DVDs and/or CDs) shipped with the
E-41 is stored in a safe location accessible to you.
Summary of Contents for E-41
Page 156: ......
