Fiery E-41, Installation And Service Manual

Page: 41 / 161

U
SING THE
E-41 41
Configuring a Static IP Address
If you are working in a DHCP network environment, do not perform the following task.
If you are working in a static network environment, you must configure a static IP address the
second time you start the Fiery controller. If you do not, the controller cannot be recognized
on the network.
T
O SETUP A STATIC
IP
ADDRESS
1. Press the “fierydriven®” button on the copier/printer and make sure that Idle appears on the
copier/printer display panel (see page 35 ).
2. Press the Fiery tab.
3. Press Setup.
4. On the Login screen, press Password. Enter Fiery.1. Press OK.
Type Fiery.1 exactly as shown. The password is case-sensitive; for example, fiery.1 will not
work.
5. On the Setup screen, do the following:
• Press WINS. If enabled (yellow), press Use WINS to disable this feature. Press Save.
• Press DNS. If enabled (yellow), press Get DNS address automatically to disable this
feature. Press Save.
• Press IP Address. Enter an IP address. Press Save.
• Press IPv4 Address. Press Manual Configuration.
6. On the Manual Configuration screen, do the following:
• In the IP Address field, enter an IPv4 address. Press OK.
• In the Subnet Mask field, enter a subnet mask IP address. Press OK.
• In the Default gateway field, enter a default gateway IP address. Press OK.
• When done, press Save. Press Go Back.
7. On the Setup screen, press Exit Setup.
8. Press Reboot Now.