S
ERVICE
P
ROCEDURES
49
Accessing internal components
This section describes how to shut down and open the E-41. Always use the following
procedures when opening the E-41 for inspection or service.
Shutting down the system
You can shut down the E-41 from the E-41 Control Panel or the copier/printer display panel.
When shutting down the E-41, do the following:
• Remove the power cable from the back panel before removing or connecting interface
cables or accessing the internal components.
• Remember that when the E-41 is powered off, network access to the copier/printer is
interrupted. Always obtain permission from the network administrator before you take the
E-41 off the network.
• If you are cycling power, wait at least 10 seconds before powering back on.
• If you are unable to shut down the E-41 through the Control Panel or the copier/printer
display panel, power off by holding down the power button on the front of the E-41 for
up to eight seconds.
• Using the reset button may cause the system to operate unpredictably. Use the reset button
on the front of the E-41 only if the system is frozen and unresponsive to keyboard or
mouse actions.
T
O
SHUT
DOWN
THE
E-41
FROM
THE
COPIER
/
PRINTER
DISPLAY
PANEL
1. Press the “fierydriven®” button on the copier/printer and make sure that Idle appears on the
copier/printer display panel (see
).
If the system has just finished processing, wait at least five seconds after the system reaches
Idle
before beginning the shutdown procedure.
2. Press the Fiery tab.
3. Press Restart Fiery.
4. At the next screen, select Shut Down.
N
OTE
:
Use the reset button on the front of the E-41 only if the system is unresponsive to
keyboard or mouse actions.
5. Press OK.
Before accessing internal components, make sure that all cables are disconnected from the
back of the E-41.
Summary of Contents for E-41
Page 156: ......
