GSM1010M Gigabit Converter
37
•
LST mode (On/Off)
The next information is regarding the type and state of connected remote device.
Following is the Down SLE and Up SLE status (On/Off), channel status
(Enable/Disable), and bandwidth values. Finally the device temperature and firmware
revision are displayed.
Device Control
This menu enables the user to change the local device’s configuration. Choosing
option 1 – will display the device status, as mentioned above. When choosing option
2 – the user can configure the FO loopback – on or off. Option 3 is used for configure
the TP loopback. Note that both loopback cannot be configured to ‘on’
simultaneously. Option 3 and option 4 are used to configure the LST modes of the
device. When selecting option 5 the user can enable or disable the channel. Option 7
is used to set the channel description. Option 8 is for restoring the factory defaults.
Selecting Option 9 is for rebooting the software. Before the reboot is performed, the
user is asked to enter a confirmation code (26974). Figure 6 displays the menu as it
appears on the terminal.
Device control:
===============
[1] System status
[2] Set FO port Loopback mode
[3] Set TP port Loopback mode
]
4
[
Set FO->TP port LST mode
[5] Set TP->FO port LST mode
[6] Enable/Disable channel
[7] Set channel description
[8] Restore default settings
[9] Reboot system
[0] Back to main menu
Figure 10
- basic status
Link management
This section enables the user to configure the links’ parameters. The access to the
remote CPE is also done from here (option 2). When choosing option 3 the user is
prompted to configure the desired bandwidth. If there were a remote device connected,
both the upstream and downstream bandwidth would be configured. Option 4 is for
configuring the Upstream SLE mode (on/off), and option 5 is used for the Downstream
SLE (on/off). The last option is restore link defaults, which mean both the local and
remote devices would be affected. A confirmation code is required to perform that.
Figure 11 displays the link management menu.
Link management:
================
[1] Link status
[2] Remote device
[3] Set link bandwidth
[4] Set Upstream SLE mode
[5] Set Downstream SLE mode
[6] Restore link default settings
[0] Back to main menu
Figure 11
- advanced status
