GSM1010M Gigabit Converter
8
6 - Installation
The device is intended for use with indoors power lines only
GSM1010M all models (including –48 VDC models):
For Desktop use
: Affix the supplied plastic “feet” (after peeling off the adhesive
protecting sheet) to the bottom of the devices, with each “foot” approximately 1 cm from
each edge. Place the device horizontally on a hard, clean surface (desk, shelf, etc.),
leaving free space around it for natural ventilation. Avoid placing the device on other
active, heat generating equipment and avoid placing such devices on the GSM1010M
units.
For wall mount installation
Attach the single channel wall mount kit (SCH – WM part # B161) with two (supplied)
screws to the base of the GSM1010M unit (select any 2 adjacent nuts: 1+2 or 3+4 or1+3
or 2+4) to achieve the desired mode of mounting. The screws to be fixed on the wall
should not protrude more than 8mm. Append the GSM1010M unit on the wall.
For Shelf installation:
Use the 19” Rack shelf (CTF-RM P/N B012) for installation of up to 3 GSM1010M units.
During the installation of several 19” Rack shelves, it is recommended to leave at least
1cm ventilation space between two adjacent racks.
