GSM1010M Gigabit Converter
26
Network parameters
•
IP address
: specify here the IP address you wish to assign the management
device. This parameter must be set correctly (according to your network) in
order to remotely control and monitor your device from a management
station.
•
Subnet mask
: specify the required subnet mask to use within the network.
•
Default gateway
: specify the default gateway to be used by the
management device where applicable.
Console parameters
•
Baud rate:
set the baud rate of communication between the GSM1010M
and the terminal. It is recommended to leave this setting at default
(9600baud).
SNMP parameters
•
Get community
: specify the get community string for the device (max 15
characters).
•
Set community
: specify the set community string for the device (max 15
characters).
•
Trap destination (1-4)
: specify the IP address (es) of the remote manager(s)
that will receive the traps sent by the GSM1010M. There is a maximum of 4
trap destinations. A 0.0.0.0 address is ignored when traps are sent.
•
Trap community
: specify the trap community string for the device (max 15
characters).
•
System name
: specify a name that identifies the device (max 18
characters).
•
System location
: specify the physical location of the device. Setting this
parameter properly helps to monitor the network and maintain order within it
(max 18 characters).
•
Contact name
: specify the person (most likely system or network
administrator) that is responsible for managing and/or handling the system
(max 18 characters).
Login parameters
•
User name
: the user name for login when starting a terminal session
through the serial connection or via Telnet. Maximum of 8 characters.
Default user name is ‘moose’. User name during login is case sensitive.
•
Password
: the password for login when starting a terminal session through
the serial connection or via Telnet. Maximum of 8 characters. Default
password is ‘1234’. Password during login is case sensitive.
•
Prompt
: the prompt string that will be displayed when using the CLI for
management. Maximum of 15 characters. Default user name is ‘FibroLAN>’.
