Fibrain FSR-R2 User’s Manual
83
Add Static Bandwidth Management (SBM) Rule
Click on Add. The following page is displayed:
Field
Description
Sequence
Number
This defines the sequence of the SBM rules. If a packet fits the
conditions set by the SBM rules, the packet will then be sorted
according to the first SBM rule from the top of the list.
Rule Name
Name of the SBM rule.
Rule Enable
Enable/Disable this SBM rule
Internal IP
Set up the internal IP for this SBM rule.
Protocol
Set up the protocol (TCP or UDP) for the ACL to be enabled.
Service Port
Range
Set up the Service Port Range (e.g., HTTP is TCP/80) for the SBM to be
enabled.
Bandwidth
Allocation
By Ratio, Group or By Bandwidth
Ratio
The ratio of the whole bandwidth according to the External Interface.
Utilize
Bandwidth More
than
Guaranteed
Check this box if you wish to allow the traffic confirming this SBM rule
to be able to utilize the whole bandwidth when the bandwidth is idle.
DSCP
Select the DSCP from the drop-down list
Remark DSCP
Select the remark DSCP from the drop-down list
Summary of Contents for FSR-R2
