FENDT 916 Vario, Operating Manual

Page: 238 / 267

238
FAULTS AND REMEDIAL ACTIONS
Front PTO
Text-module
EPC-C rear power lift
Text-module
Front power lift
Fault code Cause Effect and remedy
7.1.01 PTO key inside the cab faulty. Does not function, PTO disengages.
7.1.04 Clutch operation solenoid
faulty.
7.1.05 PTO shaft rpm sensor faulty. To engage, the button must be pressed
for at least 5 sec.
7.1.09 Automatic front PTO key on
operating console defective. Automatic mode is ended and PTO dis-
engages.
7.1.41 Cab button plausibility error. Does not function, PTO disengages.
7.1.C1 Switch-on speed not reached
for PTO/power lift automatic
mode. Increase ground speed to more than
1 km/h.
Fault code Cause Effect and remedy
8.3.11 Lift final stage defective. Control is terminated and locked.
8.3.12 Lower final stage defective. Control is terminated and locked.
8.3.14 Rear left 'Lift'key is defective. Control is terminated and locked.
8.3.15 Left rear "Lower" button faulty. Control is terminated and locked.
8.3.16 V regulator less than 1 Volt. Control is terminated and locked.
8.3.17 Battery voltage over 18 V. Control is terminated and locked.
8.3.18 Rear right 'Lift' key is defective. Control is terminated and locked.
8.3.19 Rear right 'Lower' key is defec-
tive. Control is terminated and locked.
8.3.22 Position sensor defective. Control is terminated and locked.
8.3.23 Setpoint rotary control defec-
tive. Control is terminated and locked.
8.3.26 Faulty external sensor. Control is terminated and locked.
8.3.31 Right draught sensing pin de-
fective. Control is continued
8.3.32 Left load sensor pin faulty. Control is continued
8.3.33 Battery voltage less than
10.5 V. Control is continued
8.3.40 Quick Lift switch faulty. Raise and Lower only possible with the
rear controls.
8.3.41 Fast feed-in button faulty. Fast feed-in does not function.
8.3.42 Hitch button faulty. Hitch key not functioning.
8.3.43 Automatic rear lifting gear key
(control console) defective. Automatic rear lifting gear key not opera-
tional.
8.3.50 Warning, right load sensor pin
overloaded. Warning is not stored. Relieve drafting
sensing pin of load.
8.3.51 Warning, left load sensor pin
overloaded. Warning is not stored. Relieve drafting
sensing pin of load.
Fault code Cause Effect and remedy
9.1.50 Valve not registered on CAN-
bus. Valve actuation not possible.
9.1.5F Incorrect messages sent on
CAN bus. Electronics in valve
faulty. Valve goes into neutral position.
9.1.51 Electronics in valve faulty. Valve goes into neutral position. Replace
valve.