FAZUA RIDE 50 TRAIL/STREET, Assembly Instructions Manual

Page: 9 / 32

Assembly instructions | English
9
4.2 REMOTE FX
4.2.1 Mounting REMOTE FX
notice
►
Make sure that the REMOTE cable is not kinked or under tension.
►
Make sure to lay the cables according to the manufacturer's specifications (cable routing, cable
tie holders, etc.).
►
Be careful not to damage the rubberised surface when installing the REMOTE FX and do not press
the centre button when inserting the REMOTE FX.
►
Always use needle-nose pliers to insert the plugs straight into the corresponding connection.
Be careful not to twist or bend the connectors.
►
Be sure to follow the specified connections for the speed sensor and REMOTE connectors.
Be careful not to insert the plugs into the wrong socket. The connector of the speed sensor and
the corresponding slot on the BOTTOM BRACKET are marked in green.
The slot for the REMOTE FX in the manufacturer-specific e-bike frame is provided either in
the top or downtube. It is also possible to retrofit a e-bike with the REMOTE FX. For retrofit-
ting the REMOTE FX, only the slot in the downtube is used.
Depending on the manufacturer-specific e-bike frame, you might have to remove the LOCKER
and the BOTTOM BRACKET in order to lead the REMOTE cable through the frame.
Step 1: Preparing REMOTE FX
→
Grease the rubber lips of the REMOTE FX with silicone grease before inserting it to prevent the sealing
lips from breaking during installation and the REMOTE from repeatedly sliding up out of the slot.
The amount of silicone grease to be used varies between manufacturer-specific e-bike
frames and depends on how tightly the REMOTE FX sits in the specified slot in the frame.
Step 2: Inserting REMOTE FX into the slot
Depending on the manufacturer-specific e-bike model, the REMOTE FX must first be inserted
into the adapter (optionally available from FAZUA) during initial installation before the REMOTE
FX is inserted into the slot.
→
Guide the REMOTE cable from the corresponding slot through the e-bike frame to the BOTTOM BRACKET.
Lay the cable according to the manufacturer's specifications.
→
Insert the REMOTE FX into its slot from above and
carefully press it into the frame.
When pressing the REMOTE FX into the slot, take
care not to damage the rubberised surface. Also
note that only the upper and lower sections are
pressed and not the centre button.