FAZUA RIDE 50 TRAIL/STREET, Assembly Instructions Manual

Page: 15 / 32

Assembly instructions | English
15
4.4 REMOTE RX
4.4.1 Mounting REMOTE RX
notice
►
Make sure that the REMOTE cable is not kinked or under tension.
►
Make sure to lay the cables according to the manufacturer's specifications (cable routing, cable
tie holders, etc.).
►
Always use needle-nose pliers to insert the plugs straight into the corresponding connection.
Be careful not to twist or bend the connectors.
►
Be sure to follow the specified connections for the speed sensor and REMOTE connectors.
Be careful not to insert the plugs into the wrong socket. The connector of the speed sensor and
the corresponding slot on the BOTTOM BRACKET are marked in green.
The REMOTE RX can only be mounted on handlebars with a diameter of 31.8 mm.
Depending on the manufacturer-specific e-bike frame, you might have to remove the LOCKER
and the BOTTOM BRACKET in order to lead the REMOTE cable through the frame.
Step 1: Mounting the REMOTE RX on the handlebar
→
Slide the REMOTE RX onto the handlebar from the
outside (preferably from the left side).
or
→
Open the fastening clamp by bending it open
and place the REMOTE RX on the handlebar from
above.
Be careful not to damage the cable when bending
it open.
→
Tighten the REMOTE screw (REMOTE RX Screw)
(1) 3 mm with the Allen screwdriver to fix the
REMOTE RX to the handlebar.
The REMOTE RX must be firmly and securely
attached. Also make sure to align the REMOTE RX
sensibly so that the e-bike rider can comfortably
operate the REMOTE RX while riding.
1.0–1.5 Nm
1