Fayat Bomag CR 820 T Tier 4, Operating Instructions, Maintenance Instructions

Page: 121 / 130

9 Maintenance
Date May 2020
Page 9-23
Operations Manual
CR 820 T
Figure 9.39
- Final Drive in Level Check Position
Rotate the drive until the fill plug (1) is straight up
and the level check plug (2) is 90° down from the
fill plug.
Stop the engine and perform the lockout and tagout
procedure.
Add oil into the fill plug hole until the oil reaches the
bottom of the level check plug hole.
Reinsert both the level check plug and the fill plug.
Slat Conveyor System
Conveyor Bearings
Lubricate the conveyor bearings on each conveyor
with Lithium base, type EP, Grade 2 grease.
Figure 9.40 - Front Conveyor Bearing Fittings
Figure 9.41 - Inner Rear Conveyor Bearing Fit-
tings
Figure 9.42 - Outer Rear Conveyor Bearing Fit-
tings
Two front conveyor bearing fittings (1) on each
side are near the bogie wheels or track idler. The
inner (2) and outer (3) rear conveyor bearing fit -
tings are mounted on the front and back of the
rear bulkhead.