Fayat Group DYNAPAC CC224HF, Instruction Manual

Page: 85 / 174

Operation
4812159601_H.pdf 2021-01-14
Alarm descriptions
Symbol Designation Function Symbol Designation Function
Warning lamp, hydraulic filter If the lamp comes on while the engine is running at full
speed, the hydraulic filter must be changed. Warning lamp, hydraulic filter If the lamp comes on while the engine is running at full
speed, the hydraulic filter must be changed.
Warning lamp, air filter If the lamp comes on while the engine is running at full
speed, the air filter must be cleaned or replaced. Warning lamp, air filter If the lamp comes on while the engine is running at full
speed, the air filter must be cleaned or replaced.
Warning lamp, battery charging If the lamp comes on while the engine is running, the
alternator is not charging.
Stop the engine and locate the fault. Warning lamp, battery charging If the lamp comes on while the engine is running, the
alternator is not charging.
Stop the engine and locate the fault.
Warning light, engine temperature If the lamp comes on, the engine is too hot. Stop the
engine immediately and locate the fault.
Refer also to the engine manual. Warning light, engine temperature If the lamp comes on, the engine is too hot. Stop the
engine immediately and locate the fault.
Refer also to the engine manual.
Warning lamp, hydraulic fluid
temperature If the lamp comes on, the hydraulic fluid is too hot.
Do not drive the roller. Cool the fluid by allowing the engine
to idle and locate the fault. Warning lamp, hydraulic fluid
temperature If the lamp comes on, the hydraulic fluid is too hot.
Do not drive the roller. Cool the fluid by allowing the engine
to idle and locate the fault.
Driving
Operating the roller
Fig. Control panel
1. Rpm switch
2. Parking brake
3. Forward/Reverse lever
3
1
2
Under no circumstances is the machine to be
operated from the ground. The operator must be
seated inside the machine during all operation. Under no circumstances is the machine to be
operated from the ground. The operator must be
seated inside the machine during all operation.
Activate working speed (1) = HI or ECO if available.
In ECO, the machine automatically regulates the
engine speed according to requirements.
If the machine is only to be transported, MID or ECO
should be selected instead.
Check that the steering is working correctly by turning
the steering wheel once to the right and once to the
left while the roller is stationary.
73