Fastech Ezi-Step II Plus-E MINI, User Manual, Page: 52 / 62

www.fastech.co.kr
Parameter
52
exceed 2.7[A], set value is not increased as much as
set-up, even increasing the set value.
27
Stop Current:
Stop Current is meaning of motor current which is automatically
set after 0.1 second since motor stop. This parameter is using to
decrease the temperature when motor stopped long- time. It
also can be increased the motor temperature in case set-up
more than 60%.
X10[%] 20
10 5
28
Encoder Multiply:
Set the multiplication for the input of the external encoder.
Value Pulse/Revolution
0 Not in use
1 *1
2 *2
3 *4
0 3 3
29
Encoder Direction:
Set the count direction of the encoder.
♦
0 : CW (When motor runs in CW, count increases)
♦
1 : CCW (When motor runs in CCW, count increases)
0 1 0
30
Jog EXT FUNC USE:
It is used to change Jog movement command by input signal to
other speed than setting speed in parameter No.6.
♦
0 : Not using Jog speed expand function
♦
1 : Using Jog speed expand function
There are seven additional speeds to choose from.
Speed selection is determined by the input signals Jog0, Jog1,
and Jog2.
※ 1) 1) Only jog speed by Input is applied.
2) Since Jog0~Jog2 are used in common with PT5~7, the
number of position table may be limited when using the
above function.
3) After Jog0 ~ Jog2 is input, the Jog movement command
by the signal should be input to operate normally.
Jog2 Jog1 Jog0
Setting Speed
OFF OFF OFF Parameter No.6
OFF OFF ON Parameter No.34
OFF ON OFF Parameter No.35
OFF ON ON Parameter No.36
ON OFF OFF Parameter No.37
ON OFF ON Parameter No.38
ON ON OFF Parameter No.39
ON ON ON Parameter No.40
0 1 0