- 53
APPENDIX
Evolution Lid Lift Mechanism Installation Instructions
Necessary Tools and Accessory Items:
¼ - inch wrench; 3/8 – inch wrench; 5/16 - inch wrench; cutting pliers;
(8) Cable Ties – 7-½ inch
The Fastcorp Evolution Lid Lift Mechanism can be removed and replaced in
approximately 30 to 45 minutes.
1. Locate the power switch on the left side of the Power Supply under the
delivery bin and turn it “OFF” to remove power to the VMC Board and the
Freezer Lid Lift Mechanism.
2. Reach down behind the freezer to unplug the 2 pin connector for the
circulation fan. If you cannot reach the 2 pin connector, you must move the
machine away from the wall and access the fan panel on the right rear of the
cabinet. Remove the (4) screws and unplug the fan harness.
3. Reach behind the freezer (right rear corner) to unplug the 2 pin Thermister
connector. Follow the orange wires that exit the rear opening of the right side
cabinet reinforcement bracket. The harness will be labeled, “freezer”. Be careful
of sharp edges inside the cabinet.
4. Remove the cover from the Freezer Closed Switch Assembly (right front
corner of Freezer). Make note of how the harness is plugged into the switch
(common and normally open) and then unplug the switch.
5. Note how the Freezer Lid Lift Harness is routed and where the cable ties are
positioned. Mark each location on the cabinet and the harness. Follow the
harness to the VMC Board and disconnect the connector at J3.
6. Carefully cut and remove the cable ties that hold the harness in place.
7. Manually open the Freezer Lid to access and remove the four (4) Freezer Lid
Lift Mechanism retaining screws using a 5/16-inch wrench. These screws will be
used over again to install the new mechanism.
8. Remove the Lid Lift Mechanism and carefully pull the harness through the
cabinet reinforcement bracket.
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | + 561-391-7200
